Tagged 'edge'

Heuristic Edge Select

Submitted by Swordslayer on Sun, 2014-12-28 05:35
10 votes

Select a loop of edges both on quad and non-quad geometry. Both a command without GUI and a settings dialog to fine-tune the stop cases are available.

Heuristic Edge Select Dialog

Subobjects Converter

Submitted by Nik on Fri, 2013-03-29 00:52
9 votes


v3.06
When importing models, there is often a single first smoothing group when the object is broken into elements. When seams are welded together, the result is not a model with faces, but a monolithic piece by Smoothing group.
To solution this problem: In subobjects 5 (Elements) added a function to assign a different smoothing group to each element. To RUN this function press ESC+5. After that all seams of surfaces can be soldered normally.

miauu's Scalpel

Submitted by miauu on Sun, 2019-09-01 03:21
8 votes

maxUnChamfer

Submitted by RappyBMX on Mon, 2011-08-08 04:36
7 votes

maxUnChamfer will help you produce low poly objects in less time with less amount of effort .

Here are some of the benefits you get:

Uni-Chamfer

Submitted by Nik on Thu, 2013-07-04 00:30
6 votes 

Using single one hotkey of Chamfer, works with:
Используя единственную горячую кнопку для Chamfer, работает с:
Edit_Poly: [Vertices, Edges, Faces(inset)] 
Editable_poly: [Vertices, Edges, Faces(inset)] 
Edit_mesh: [Vertices, Edges] 
Editable_mesh: [Vertices, Edges] 
Edit_Spline: [knots (Fillet), 
Spline sub-obj (Outline)] 
SplineShape: [knots (Fillet), Spline sub-obj (Outline)] 
line: [knots (Fillet), 
Spline sub-obj (Outline)]

Poly Loop Soft Select

Submitted by Royal Ghost on Thu, 2015-07-02 09:59
5 votes

Poly Loop Soft Select – 3dsmax MAXScript, allows when working with Editable Poly object in Edge sub-object mode filter Soft Selection by selected edge’s loop.

When Poly Loop Soft Select filter Soft Selection only edges which connected to selected edge will remain.

Edge Loop Straighten with Constraints

Submitted by PolyHertz on Sat, 2019-07-20 06:18
4 votes

Edge Loop Straighten with Constraints works like this:
Selected one or more partial loop(s) of edges, run the script, and it will straighten all the verts between the end verts of the loop(s). What makes this script different from others of its kind is that it fully supports all three geometry constraint modes; edge, face, and normal constraints.

miauu's Transfer Edges: Poly <-> UVW

Submitted by miauu on Sat, 2017-10-21 14:51
3 votes

Select Faces By 2 Edges

Submitted by Budi G on Sat, 2013-09-14 22:51
2 votes

Select a Loop Faces between two selected Edges.

Connect Edges

Submitted by Lalouche on Fri, 2020-07-03 14:40
1 vote

Just a simple modifier to connect edges selected with the previous "edit poly" "editable poly" or "poly select" modifier. Currently I tested my script on 3dsmax 2020, I will try to test it on older version of 3ds max and update this page if I can. If you have any question or any requirement, don't hesitate to ask me or to contact me. I will be happy to answer you.

Syndicate content